Slim Filterhousing Accessories

Wrench for Vana Slim Filter Housings.

For an easier access and changing of filters.

Easy steps to changing the filter:

• Shut the water off.
• Open a faucet to let out access water.
• Open the vent valve.
• Insert the key from below and twist slowly to open the filter housing and take out the used filter.
• Clean/wipe the glass and insert new filter.
• Close and softly tighten the housing using the key.
• Slowly open the water again and when the air is out, shut off the faucet and carefully open the vent valve to let out any remaining air.

Ready to go!

We always recommend changing the filters every 6 months to avoid bacteria growth in the filters and to ensure the best efficiency. Please note, that depending on the water quality it may vary how often it needs changing.

O-ring for Vana filter housings.

Vana Slim wall mount for all of our Slim housings.

Certified Sealing Tape

Double Nipple 3/4" - 3/4" is used to connect to filter housings.

Double Nipple Union is used to connect two housings 

Brass

Connection is 3/4"

Ball Valve 3/4" in Brass. When you need to change your filter, the Ball Valve allows you to close the system.

Mini Ball Valve Female (internal thread) in Brass. Good to have when changing filters, to close the system.

Vana Installation Kit 3/4" - Used to install Vana Housings.

FRL Ball Valve 2-piece RP 3/4" - Used when you change filters, to close the system.